SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE GENERAL INFORMATION & DIAGNOSISDIAGNOSTIC INFORMATION AND PROCEDURESDTC P0481: FAN 2 CONTROL CIRCUITDTC DETECTING CONDITION AND TROUBLE AREA
2013 Suzuki SX4 Crossover, Automatic CVT Trans

DTC Detecting Condition and Trouble Area

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION DTC Detecting Condition and Trouble Area
DIAGNOSTIC INFORMATION AND PROCEDURES REFERENCE CHART

DTC detecting condition Trouble area
P0481: Fan 2 Control Circuit 
This DTC is detected if any one of the following conditions is met.
  • Monitor signal of radiator cooling fan relay No. 2 and No. 3 drive circuit is high level (OFF) for 5 sec. even if command signal of radiator cooling fan is at high speed.
  • Monitor signal of radiator cooling fan relay No. 2 and No. 3 drive circuit is low level (ON) for 5 sec. even if command signal of radiator cooling fan is NOT at high speed.

(2 D/C detection logic but MIL does not light up)
  • Radiator cooling fan relay No. 2 (coil side) and/or its circuit
  • Radiator cooling fan relay No. 3 (coil side) and/or its circuit
  • ECM
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.