Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM & WASHER SYSTEMREPAIR INSTRUCTIONSWINDSHIELD WIPER AND WASHER SWITCH REMOVAL AND INSTALLATIONREMOVAL
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Windshield Wiper and Washer Switch Removal and Installation: Removal
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Removal
- Disconnect negative (-) cable at battery.
- Remove steering column hole cover (1).
- Remove steering column covers (2).
Turn steering wheel to access steering column cover rear end screws (3).
- (Immobilizer model)
Remove immobilizer control module referring to ICM REMOVAL AND INSTALLATION .
- Remove windshield wiper and washer switch (if equipped) (1) from combination switch assembly (2) and disconnect its coupler (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.