Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSSECURITY & LOCKS
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Security & Locks
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Security & Locks
- General Description
- Component Location
- Diagnostic Information and Procedures
- Power Door Lock System Symptom Diagnosis
- Power Door Lock System Operation Inspection
- Keyless Entry System Symptom Diagnosis (If Equipped)
- Keyless Entry System Operation Inspection (If Equipped)
- Door Lock Function of Keyless Start System Symptom Diagnosis (If Equipped)
- Rear End Door Opener System Symptom Diagnosis
- Rear End Door Opener System Operation Inspection
- Keyless Entry Receiver and Its Circuit Inspection (If Equipped) (2013)
- Repair Instructions
- Front Door Lock Assembly Components
- Front Door Lock Assembly Removal and Installation
- Front Door Lock Assembly Inspection
- Power Door Lock Switch Inspection
- Door Key Cylinder Switch Inspection
- Power Door Lock Actuator Inspection
- Rear Door Lock Assembly Components
- Rear Door Lock Assembly Removal and Installation
- Rear Door Lock Assembly Inspection
- Rear End Door Lock Assembly Components (Hatchback)
- Rear End Door Lock Assembly Removal and Installation (Hatchback)
- Rear End Door Lock Assembly Inspection (Hatchback)
- Rear End Door Opener Switch Inspection (Hatchback)
- Trunk Lid Lock Assembly Components (Sedan)
- Trunk Lid Lock Assembly Removal and Installation (Sedan)
- Trunk Lid Lock Assembly Inspection (Sedan)
- Replacement of Transmitter Battery (Other than Keyless Start Model)
- Programming Transmitter Code for Keyless Entry System (Other than Keyless Start Model)
- Keyless Entry Receiver Removal and Installation (If Equipped)
- Keyless Entry Receiver and Its Circuit Inspection (If Equipped) (2012)
- Specifications
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.