Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISSTEERINGPOWER STEERINGPOWER ASSISTED STEERING SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESP/S WARNING LIGHT CHECK
2013 Suzuki Kizashi Sport GTS, FWD
P/S Warning Light Check
2013 Suzuki Kizashi Sport GTS, FWDSECTION P/S Warning Light Check
- Push engine switch to change ignition mode of keyless push start system to "ON" (without engine running) and check if "P/S" warning light (1) comes on. If the light does not come on, go to P/S WARNING LIGHT DOES NOT COME ON WITH IGNITION MODE CHANGE TO "ON" BEFORE ENGINE STARTS of the diagnostic flows.
- Start engine and check if "P/S" warning light turns OFF. If light remains ON and no DTC is detected, go to P/S WARNING LIGHT REMAINS ON STEADY AFTER ENGINE STARTS for troubleshooting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.