SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (MANUAL TRANSAXLE)REPAIR INSTRUCTIONSMANUAL TRANSAXLE ASSEMBLY DISASSEMBLY AND REASSEMBLYDISASSEMBLY
2013 Suzuki Kizashi Sport GTS, FWD

Manual Transaxle Assembly Disassembly and Reassembly: Disassembly

2013 Suzuki Kizashi Sport GTS, FWDSECTION Disassembly
WARNING: This page is about a different variant/trim than selected.
  1. Remove back up light switch, see back Up Light Switch Removal And Installation .
  2. Remove transaxle case bolts.
  3. Remove transaxle left side case (1) from right case using special tool.

    Special Tool 

    1. 09912-34510 
    Fig 1: Removing Transaxle Left Side Case From Right Case Using Special Tool
    G06528785Courtesy of SUZUKI OF AMERICA CORP.
  4. Remove reverse gear shift lever bolts (1) and reverse gear shift lever (2).
    Fig 2: Identifying Reverse Gear Shift Lever Bolts And Reverse Gear Shift Lever
    G06528786Courtesy of SUZUKI OF AMERICA CORP.
  5. Tapping input shaft end with plastic hammer, push it out as assembly from case a little, and then remove input shaft assembly (1), countershaft assembly (2), high speed gear shift shaft (3), low speed gear shift shaft (4), 5th and 6th gear shift shaft (5), reverse gear shift (6) and reverse gears (7).
    Fig 3: Identifying Input Shaft Assembly, Countershaft Assembly, High Speed Gear Shift Shaft And Low Speed Gear Shift Shaft
    G06528787Courtesy of SUZUKI OF AMERICA CORP.
  6. Remove differential assembly from right case.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.