SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 70 (FRONT SUSPENSION & WHEEL ALIGNMENT)REPAIR INSTRUCTIONSFRONT STRUT ASSEMBLY INSPECTION
2013 Suzuki Kizashi Sport GTS, FWD

Front Strut Assembly Inspection

2013 Suzuki Kizashi Sport GTS, FWDSECTION Front Strut Assembly Inspection
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.

Reference: FRONT STRUT ASSEMBLY REMOVAL AND INSTALLATION 

WARNING: When handling front strut assembly (1) in which low-pressure gas and oil are sealed, make sure to observe the following precautions.
  • Do not disassemble the assembly.
  • Do not put the assembly into the fire.
  • Do not store the assembly where it gets hot.
  • Before disposing of the assembly, be sure to drill a hole (approximately 3 mm (0.1 in.) in diameter) (2) in it at location shown in figure to let low-pressure gas and oil out. Be sure to wear eye shield since low-pressure gas discharged may be accompanied by drill swarf although the gas is harmless.
    Fig 1: Drilling Hole On Front Strut Assembly
    G06529899Courtesy of SUZUKI OF AMERICA CORP.
  • Inspect strut for oil leakage, damage or deformation.

    If defect is found, replace strut as an assembly unit, because it cannot be disassembled.

    Fig 2: Locating Strut For Oil Leakage, Damage Or Deformation
    G06529900Courtesy of SUZUKI OF AMERICA CORP.
  • Inspect front strut assembly function using the following procedure:
    1. Check and adjust tire pressures to specification.
    2. Bounce vehicle body up and down 3 or 4 times, continuously by pushing front end of vehicle's side body on one side to check strut assembly.

      Also, note how many times vehicle body rebounds to stop after force application.

    3. Repeat the same procedure to the other strut to confirm that the both side struts equally respond.

      If conditions of struts are in doubt, compare them with known-good vehicle or strut.

  • Inspect spring upper seat for cracks or deformation. If defective, replace spring upper seat.
  • Inspect strut bearing and bump stopper for wear, cracks or deformation. If defective, replace front strut bearing and bump stopper.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.