Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 65 (BRAKE CONTROL SYSTEM AND DIAGNOSIS)SPECIFICATIONSTIGHTENING TORQUE SPECIFICATIONS
2013 Suzuki Kizashi Sport GTS, FWD
Tightening Torque Specifications
2013 Suzuki Kizashi Sport GTS, FWDSECTION Tightening Torque Specifications
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kgf-m | lbf-ft | |
| Brake pedal bracket bolt | 13 | 1.3 | 9.5 |
| Brake booster nut | 13 | 1.3 | 9.5 |
| Brake pedal bracket nut | 13 | 1.3 | 9.5 |
| Pedal shaft nut | 23 | 2.3 | 17.0 |
| Brake master cylinder fixing nut | 13 | 1.3 | 9.5 |
| Brake pipe flare nut | 19 | 1.9 | 14.0 |
NOTE:
The specified tightening torque is described in the following.
BRAKE PEDAL COMPONENTS
BRAKE HOSE AND PIPE COMPONENTS
BRAKE MASTER CYLINDER COMPONENTS
BRAKE BOOSTER COMPONENTS
BRAKE PEDAL COMPONENTS
BRAKE HOSE AND PIPE COMPONENTS
BRAKE MASTER CYLINDER COMPONENTS
BRAKE BOOSTER COMPONENTS
Reference:
For the tightening torque of fastener not specified in this section, refer to FASTENERS INFORMATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.