Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (CELLULAR/ENTERTAINMENT/NAVIGATION/AUDIO)DIAGNOSTIC INFORMATION AND PROCEDUREVIDEO ENTERTAINMENT SYSTEM INOPERATIVECIRCUIT/SYSTEM TESTING
2013 Suzuki Kizashi Sport GTS, FWD
Circuit/System Testing
2013 Suzuki Kizashi Sport GTS, FWDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If rear video display turns ON but the video is blank, use diagnostic VIDEO DISPLAY IS POOR OR BLANK .
- Disconnect the video display harness connector. With the ignition ON, operate the rear entertainment system. Verify there is voltage on the remote enable signal circuit.
- If voltage is not present on the remote enable signal circuit, test and repair open or short to ground.
- If the enable signal circuit tests normal but there is no voltage, replace the radio.
- Test and repair open, short to ground and short to power on the ground and battery positive voltage circuits at the video display.
- If the video display power and ground circuits test normal, replace the rear video display.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.