Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 41 (FUEL SYSTEM)REPAIR INSTRUCTIONSFUEL TANK PRESSURE SENSOR REPLACEMENTREMOVAL PROCEDURE
2013 Suzuki Kizashi Sport GTS, FWD
Removal Procedure
2013 Suzuki Kizashi Sport GTS, FWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the fuel tank. Refer to REMOVAL PROCEDURE and REMOVAL PROCEDURE .
- Disconnect the fuel pump module harness electrical connector from the fuel tank pressure sensor.
- Position 2 flat-bladed screwdrivers, one on each side of the sensor, near the vacuum port.
- Carefully use the screwdrivers to lift and release the sensor from the fuel pump module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.