Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 39 (ENGINE ELECTRICAL DEVICES)REPAIR INSTRUCTIONENGINE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2013 Suzuki Kizashi Sport GTS, FWD
Installation Procedure
2013 Suzuki Kizashi Sport GTS, FWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the ECM into the retainer until the clips (1) engage the ECM.
- Grasp the ECM retainer and slide the retainer forward until the retainer locks against the 4 clips on the battery cover.
- Connect the engine wiring harness electrical connector (2) to the ECM.
- Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECTION AND CONNECTION .
- If a NEW ECM was installed, reprogram the ECM. Refer to ENGINE CONTROL MODULE PROGRAMMING AND SETUP .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.