Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 30 (ENGINE MECHANICAL)REPAIR INSTRUCTIONSENGINE FRONT COVER REPLACEMENTINSTALLATION PROCEDURE

2013 Suzuki Kizashi Sport GTS, FWD

Installation Procedure

2013 Suzuki Kizashi Sport GTS, FWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Guide

Courtesy of SUZUKI OF AMERICA CORP.

Install the 8 mm (0.315 in) guide from the EN 46109 into the cylinder block positions as shown in Fig 1.

Fig 2: Identifying Cylinder Block Seal
Courtesy of SUZUKI OF AMERICA CORP.
Install the engine front cover to cylinder block seal.

Fig 3: Placing Bead Of RTV Sealant On Engine Front Cover
Courtesy of SUZUKI OF AMERICA CORP.
Place a 3 mm (0.118 in) bead of RTV sealant, GM P/N 12378521 (Canadian P/N 88901148) or equivalent, on the engine front cover as shown in Fig 3 (1).

Fig 4: Identifying Engine Front Cover
Courtesy of SUZUKI OF AMERICA CORP.
Place the engine front cover onto the EN 46109 and slide into position.
Remove the EN 46109 from the cylinder block.

Fig 5: Identifying Front Cover Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Hand start all the front cover bolts.

Fig 6: Tightening Engine Front Cover Bolts In Sequence
Courtesy of SUZUKI OF AMERICA CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.