Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 24 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSWATER PUMP REPLACEMENTINSTALLATION PROCEDURE

2013 Suzuki Kizashi Sport GTS, FWD

Installation Procedure

2013 Suzuki Kizashi Sport GTS, FWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Water Pump Seal & Water Pump Bolts (2 Of 2)

Courtesy of SUZUKI OF AMERICA CORP.

Install a NEW water pump seal.
Install the water pump.
CAUTION: Refer to FASTENER NOTICE .
Install the water pump bolts.
Tightening torque

Tighten the water pump bolts to 10 N.m (89 lb in) .

Fig 2: Identifying Water Pump Pulley & Water Pump Pulley Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Install the water pump pulley and the water pump pulley bolts.

Fig 3: Installing Water Pump Pulley Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Use the EN 46104 in order to retain the water pump pulley.
Install the water pump pulley bolts.
Tightening torque

Tighten the water pump pulley bolts to 10 N.m (89 lb in) .
Install the drive belt. Refer to INSTALLATION PROCEDURE .
Fill the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM (LY7 GE 47716 FILL) and DRAINING AND FILLING COOLING SYSTEM (LY7 STATIC FILL) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.