Remote Control Door Lock Receiver Replacement

2013 Suzuki Kizashi Sport GTS, FWDSECTION Remote Control Door Lock Receiver Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remote Control Door Lock Receiver Component And Placement
G04844529Courtesy of SUZUKI OF AMERICA CORP.
REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT REFERENCE

Callout Component Name
Preliminary ProcedureΒ 
Remove the right side lock pillar upper garnish molding. Refer to LOCK PILLAR UPPER GARNISH MOLDING REPLACEMENT (LEFT SIDE) and LOCK PILLAR UPPER GARNISH MOLDING REPLACEMENT (RIGHT SIDE) .
1 Remote Control Door Lock Receiver
Tip:Β  Push in on the upper two integral tabs to release the receiver from the body side.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.