SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (AUTOMATIC TRANSMISSION)REPAIR INSTRUCTIONSCONTROL VALVE BODY COVER REPLACEMENTINSTALLATION PROCEDURE
2013 Suzuki Kizashi Sport GTS, FWD

Installation Procedure

2013 Suzuki Kizashi Sport GTS, FWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Control Valve Body Cover (2 Of 2)
G04845958Courtesy of SUZUKI OF AMERICA CORP.
  1. Clean any gasket material from the control valve body cover and inspect the gasket mounting surface.
  2. Install a 3 mm (0.125 in) bead of RTV sealer GM P/N 89020326 (Canadian P/N 89021188) onto the control valve body cover.
    Fig 2: Identifying Control Valve Body Cover Bolts
    G04845959Courtesy of SUZUKI OF AMERICA CORP.
  3. Install the control valve body cover (1) onto the transaxle case.
    NOTE: Use LOCTITE™ 242 thread sealer on ALL bolt threads.
  4. Install the control valve body cover bolts (2) hand tight.
    Fig 3: Identifying Tightening Sequence Of Control Valve Body Cover Bolts
    G04845960Courtesy of SUZUKI OF AMERICA CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.