Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (LIGHTING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESREADING LAMP(S) INOPERATIVECIRCUIT/SYSTEM TESTING
2013 Suzuki Kizashi Sport GTS, FWD
Circuit/System Testing
2013 Suzuki Kizashi Sport GTS, FWDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the reading lamp switch.
- Test for less than 1.0 Ξ© of resistance between the ON circuit and ground.
- If greater than 1.0 Ξ©, test the ON circuit for an open/high resistance.
- Install a test lamp between the signal circuit and ground. Verify the test lamp turns ON.
- If the test lamp does not turn ON, test the signal circuit of the reading lamp switch for a short to ground or an open/high resistance.
- If all circuits test normal, test or replace the reading lamp assembly or the reading lamp bulb.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.