Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISBODY & FRAMEGLASS/WINDOWS/MIRRORS (2)REPAIR INSTRUCTIONSPOWER WINDOW SYSTEM INITIALIZATION/RESET (FRONT WINDOWS ONLY)RESETTING AFTER REPLACING FRONT WINDOW REGULATOR ASSEMBLY
2013 Suzuki Kizashi Sport GTS, FWD
Resetting after Replacing Front Window Regulator Assembly
2013 Suzuki Kizashi Sport GTS, FWDSECTION Resetting after Replacing Front Window Regulator Assembly
- Push engine switch to change ignition mode of keyless start system to "ON" (with vehicle stopped).
- Pull up and hold power window switch in AUTO position until window glass reaches its fully closed position and continue holding it up for about 7 seconds.
- Push down and hold power window switch until window glass reaches its fully open position (lowest position) and continue holding it down for about 2 seconds.
- Release power window switch temporarily and then press down and hold the power window switch again for approximately 5 seconds at Auto DOWN position.
- Pull up and hold power window switch in AUTO position until window glass reaches its fully closed position and continue holding it up for about 2 seconds.
- Perform Auto DOWN and Auto UP operations to check that door glass can be opened and closed fully. Repeat procedure from Step 1) if Auto DOWN or Auto UP function does not work.
- Check anti-pinching function, see INSPECTION OF POWER WINDOW ANTI-PINCHING FUNCTION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.