Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSCONTINUOUSLY VARIABLE TRANSAXLE (CVT)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P0602: CONTROL MODULE PROGRAMMING ERRORDTC DETECTING CONDITION AND TROUBLE AREA
2013 Suzuki Kizashi Sport GTS, FWD
DTC Detecting Condition and Trouble Area
2013 Suzuki Kizashi Sport GTS, FWDSECTION DTC Detecting Condition and Trouble Area
NOTE:
After reprogramming of TCM is executed, if the DTC P0602 is indicated, it is possible that the reprogramming of TCM is not completed correctly.
DTC DETECTING CONDITION CHART
| DTC detecting condition | Trouble area |
|---|---|
| P0602: Control Module Programming Error TCM internal failure (data programming error). (1 D/C detection logic but MIL does not light up) |
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.