Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS START SYSTEMGENERAL DESCRIPTIONDESCRIPTION OF KEYLESS START SYSTEM TRUNK LID OPENER FUNCTIONUNLOCKING USING TRUNK LID REQUEST SWITCHNOTES
2013 Suzuki Kizashi Sport GTS, FWD
Unlocking Using Trunk Lid Request Switch: Notes
2013 Suzuki Kizashi Sport GTS, FWDSECTION Notes
The method for unlocking trunk lid using trunk lid request switch is as follows.
- Push trunk lid request switch (1) in trunk lid.
- Keyless start control module (2) activates mid inside antenna (3) and rear inside antenna (4) to transmit within the vehicle compartment and trunk room.
- When keyless start control module determines that remote controller (5) is not in vehicle compartment and trunk room, it activates rear outside antenna (6) to send request signal to remote controller.
- Remote controller receives request signal and then sends ID code to keyless start control module via keyless entry/TPMS receiver (7).
- Keyless start control module compares ID code sent from remote controller with ID code registered in keyless start control module. If ID codes match, keyless start control module outputs trunk lid opener request signal to BCM (8) through CAN communication.
- BCM activates trunk lid opener actuator (9).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.