Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2012KIZASHI SPORT GTS, FWD, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESAXLE SHAFTSDRIVE SHAFT/AXLE - FRONTSPECIFICATIONSTIGHTENING TORQUE SPECIFICATIONS
2012 Suzuki Kizashi Sport GTS, FWD, Standard Trans
Tightening Torque Specifications
2012 Suzuki Kizashi Sport GTS, FWD, Standard TransSECTION Tightening Torque Specifications
CAUTION:
For fastener with * (asterisk) below, be sure to tighten it according to specified procedure in "Repair Instructions".
TORQUE SPECIFICATION
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kgf-m | lbf-ft | |
| Drive shaft nut* | 250 | 25.5 | 184.5 |
| Intermediate support bolt* | 55 | 5.6 | 40.5 |
| Front wheel hub assembly bolt | 70 | 7.1 | 52.0 |
NOTE:
The specified tightening torque is described in the following.
Reference:
For the tightening torque of fastener not specified in this section, refer to:
.RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.