Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2012KIZASHI SPORT GTS, FWD, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSIMMOBILIZER CONTROL SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC TABLEKEYLESS START CONTROL MODULE
2012 Suzuki Kizashi Sport GTS, FWD, Standard Trans
Keyless Start Control Module
2012 Suzuki Kizashi Sport GTS, FWD, Standard TransSECTION Keyless Start Control Module
DTC DETECTING CONDITION CHART
| DTC | DTC name | DTC detecting condition | Warning |
|---|---|---|---|
| B1167 | Immobilizer Information Mismatched | Verification error between keyless start control module and ECM. | Lights up |
| B1168 | Password Mismatched | Wrong password is inputted. | Off |
| B1169 | Registered Failure | Registration failure of ECM or remote controller. | Off |
| B1173 | Transponder Unregistered | Transponder code in the transponder built in remote controller is not registered. | Lights up |
| B1175 | Immobilizer Information Unregistered | Immobilizer ID code is not registered in keyless start control module. | Lights up |
| B1176 | Specification Information Unregistered | Vehicle specification is not registered in keyless start control module. | Lights up |
| B1189 | Immobilizer Antenna Communication Error | Communication error with engine switch (built-in immobilizer coil antenna). | Lights up |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.