SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2012KIZASHI SPORT GTS, FWD, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSEATSREPAIR INSTRUCTIONSSEAT POSITION MEMORY INITIALIZATION (IF EQUIPPED)
2012 Suzuki Kizashi Sport GTS, FWD, Standard Trans

Seat Position Memory Initialization (If Equipped)

2012 Suzuki Kizashi Sport GTS, FWD, Standard TransSECTION Seat Position Memory Initialization (If Equipped)
NOTE:
  • Initialization is not completed if power supply of power seat control module is interrupted during initialization.

    Repeat the same procedure from the beginning if power is interrupted during initialization.

  • Buzzer sounds twice when initialization of all motors is completed.
  1. Operate each motor, one at a time, to move seat to position indicated in the following table and hold seat at each position for at least 5 seconds.
    MOTOR POSITION CHART

    Motor Position
    Slide motor Rear end
    Reclining motor Front end
    Lifter motor Bottom end
    Tilt motor Bottom end
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.