SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2012KIZASHI SPORT GTS, 4WDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSCONTINUOUSLY VARIABLE TRANSAXLE (CVT)REPAIR INSTRUCTIONSTCM INITIALIZATION AND LEARNING CONTROLINITIALIZATION PROCEDURE
2012 Suzuki Kizashi Sport GTS, 4WD

Initialization Procedure

2012 Suzuki Kizashi Sport GTS, 4WDSECTION Initialization Procedure
  1. Select initialization procedure from table below.
    SERVICE ITEM REFERENCE

    Initialization procedure Service item
    [A] When replace TCM with new one
    [B]
    • When Replacing TCM with used one
    • When Replacing CVT assembly
    • When replacing valve body assembly
  2. Perform selected INITIALIZATION PROCEDURE  as follows.

    Initialization procedure [A]: 

    1. Push engine switch to change ignition mode to "ON" and shift select lever to "P" range.
    2. Check that the shift position indicated in information display comes on in approx. 2 sec. after engine switch is pressed to change ignition mode to "ON". If the shift position does not come on, check the following items:
      • Check for open or shorted to ground in wiring harness between TCM and ROM in CVT assembly, see INSPECTION OF TCM AND ITS CIRCUITS .
      • Check for proper terminal connection to TCM connector and solenoid connector.

    Initialization procedure [B]: 

    1. Confirm that ignition mode of keyless push start system is "OFF" and connect SUZUKI scan tool to DLC (1).

      Special Tool 

      1. SUZUKI scan tool (SUZUKI-SDT) 
      Fig 1: Connecting SUZUKI Scan Tool To DLC
      G06527857Courtesy of SUZUKI OF AMERICA CORP.
    2. Push engine switch to change ignition mode to "ON".
    3. Select "Learning Value Initialization" function under "Utility" mode on SUZUKI scan tool, and follow the instructions displayed on SUZUKI scan tool.
    4. Push engine switch to change ignition mode to "OFF" and leave ignition mode in "OFF" for 10 sec.
    5. Shift select lever to "P" range.
    6. Check that the shift position indicated in information display comes on in approx. 2 sec. after engine switch is pressed to change ignition mode to "ON". If the shift position does not come on, check the following items:
      • Check wiring harness between TCM and ROM in valve body assembly for open circuit or short circuit to ground, See INSPECTION OF TCM AND ITS CIRCUITS .
      • Check for proper terminal connection to TCM connector and solenoid connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.