Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2012KIZASHI SPORT GTS, 4WDREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSSPECIFICATIONSTIGHTENING TORQUE SPECIFICATIONS
2012 Suzuki Kizashi Sport GTS, 4WD
Tightening Torque Specifications
2012 Suzuki Kizashi Sport GTS, 4WDSECTION Tightening Torque Specifications
NOTE:
For fastener with * (asterisk) below, be sure to tighten it according to specified procedure in "Repair Instructions".
TIGHTENING TORQUE SPECIFICATIONS
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kgf-m | lbf-ft | |
| Tensioner bolt | 25 | 2.5 | 18.5 |
| Idler pulley nut | 40 | 4.1 | 29.5 |
| Generator bolt* | 45 | 4.6 | 33.5 |
| "B" terminal nut | 11 | 1.1 | 8.5 |
| Bearing retainer screw | 2.3 | 0.23 | 2.0 |
| Pulley nut | 110 | 11.2 | 81.5 |
| Stator assembly bolt | 6.0 | 0.61 | 4.5 |
| Brush holder screw | 2.0 | 0.20 | 1.5 |
| Rear end cover nut | 4.5 | 0.46 | 3.5 |
NOTE:
The specified tightening torque is described in the following.
Reference:
For the tightening torque of fastener not specified in this section, refer to:
.RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.