Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Description of Ignition Mode Switching Procedure
Push engine switch without depressing the brake pedal (CVT model) or clutch pedal (M/T model), and while information display indicates "PLACE KEY FOB ON START SWITCH" for about 10 seconds, place remote controller on engine switch for about 2 seconds. Through this process, keyless start control module checks remote controller ID code, and keyless start control module permits switching of ignition mode according to operational state of the engine switch only when code corresponds with the registered code.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.