Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Suzuki Equator BaseFACTORY OEM SERVICE PROCEDURE
Section 2 (Transfer)
WARNING: This page is about a different variant/trim than selected.
- Precautions
- General Description
- 4WD System: System Description
- 4WD System: CAN Communication
- Cross-Sectional View
- 4WD System: Power Transfer
- Schematic and Routing Diagram
- Component Location
- Diagnostic Information and Procedures
- Diagnosis and Repair Workflow
- SDT Function (4WD)
- NVH Troubleshooting Chart
- Transfer Control Unit: Reference Value
- DTC Index: Transfer Control Unit
- DTC Index
- DTC P1801 & DTC P1811: Power Supply Circuit for Transfer Control Unit
- DTC P1802, DTC P1803, DTC P1804 & DTC P1809: Transfer Control Unit
- DTC P1807: Vehicle Speed Sensor (A/T)
- DTC P1808: Vehicle Speed Sensor (ABS)
- DTC P1810: 4 LO Switch
- DTC P1813: 4WD Shift Switch
- DTC P1814: Wait Detection Switch
- DTC P1816: PNP Switch (A/T)
- DTC P1816: PNP Switch (M/T)
- DTC P1817: Actuator Motor
- DTC P1818: Actuator Position Switch
- DTC P1819: Transfer Control Device
- DTC P1820: Engine Speed Signal
- DTC U1010: Control Unit (CAN)
- ATP Switch Circuit Check
- 4WD System Symptoms: Symptom Table
- 4WD Warning Lamp Does Not Turn On
- 4WD Shift Indicator Lamp and 4Lo Indicator Lamp Do Not Turn On
- 4WD Shift Indicator Lamp or 4Lo Indicator Lamp Do Not Change
- ATP Warning Lamp Does Not Turn On
- 4WD Shift Indicator Lamp Keeps Flashing
- 4WD Warning Lamp Flashes Slowly
- Repair Instructions
- Transfer Fluid: Inspection
- Transfer Fluid: Replacement
- Transfer Control Unit: Removal and Installation
- Front Oil Seal: Removal and Installation
- Rear Oil Seal: Removal and Installation
- Transfer Control Device: Removal and Installation
- Air Breather Hose: Removal and Installation
- Transfer Assembly: Exploded View
- Transfer Assembly: Removal and Installation
- Transfer Assembly: Disassembly and Assembly
- Planetary Carrier: Disassembly and Assembly
- Front Drive Shaft: Disassembly and Assembly
- Shift Control: Disassembly and Assembly
- Specifications
- Special Tools and Equipment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.