Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2010KIZASHI FWD L4-2.4LREPAIR AND DIAGNOSISBODY AND FRAMESENSORS AND SWITCHES - BODY AND FRAMETRUNK / LIFTGATE SWITCHSERVICE AND REPAIRTRUNK LID REQUEST SWITCH REMOVAL AND INSTALLATION
2010 Suzuki Kizashi FWD L4-2.4L
Trunk Lid Request Switch Removal And Installation
2010 Suzuki Kizashi FWD L4-2.4LSECTION Trunk Lid Request Switch Removal And Installation
Trunk Lid Request Switch Removal and Installation
Removal
1. Disconnect negative (-) cable at battery.
2. Remove trunk lid trim.
3. Disconnect trunk lid request switch connector (1) and clip.
4. Remove screws, and then remove trunk lid request switch (2).
Installation
Reverse removal procedure.
Removal
1. Disconnect negative (-) cable at battery.
2. Remove trunk lid trim.
3. Disconnect trunk lid request switch connector (1) and clip.
4. Remove screws, and then remove trunk lid request switch (2).
Installation
Reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.