Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2010KIZASHI FWD L4-2.4LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYTECHNICAL SERVICE BULLETINSKEYLESS SYSTEMS - TRANSMITTER REGISTRATION PROCEDUREOVERVIEW
2010 Suzuki Kizashi FWD L4-2.4L
Keyless Systems - Transmitter Registration Procedure: Overview
2010 Suzuki Kizashi FWD L4-2.4LSECTION Overview
Section Title: Control Systems
TSB No: TS 03 12170
Division: Automotive
Category: Technical
SUBJECT: KEYLESS REMOTE CONTROLLER REGISTRATION PROCEDURE
MODEL(S): KIZASHI (A6B424)
YEAR: 2010
CONDITION:
Registering one or more keyless remote controllers through the "Immobilizer Key Registration" function.
CAUSE:
The addition of new keyless remote controllers, the replacement of lost keyless remote controllers, or the replacement of the keyless start control module.
CORRECTION:
Follow the steps listed in this bulletin to properly register the keyless remote controllers.
> Register remote controller ID code using "Immobilizer Key Registration" function using the SUZUKI SDT scan tool.
> Remote controller registration is performed through "Immobilizer Key Registration", and this registers the immobilizer transponder code.
> It is possible to register up to 4 remote controllers in the keyless start control module.
> If the keyless start control module is replaced, you must reprogram all of the remote controllers. The TPMS sensors will also need to be registered again to the new controller.
> If all of the remote controllers are lost, the keyless start control module must be replaced before any remote controllers can be registered.
TOOLS REQUIRED
TSB No: TS 03 12170
Division: Automotive
Category: Technical
SUBJECT: KEYLESS REMOTE CONTROLLER REGISTRATION PROCEDURE
MODEL(S): KIZASHI (A6B424)
YEAR: 2010
CONDITION:
Registering one or more keyless remote controllers through the "Immobilizer Key Registration" function.
CAUSE:
The addition of new keyless remote controllers, the replacement of lost keyless remote controllers, or the replacement of the keyless start control module.
CORRECTION:
Follow the steps listed in this bulletin to properly register the keyless remote controllers.
> Register remote controller ID code using "Immobilizer Key Registration" function using the SUZUKI SDT scan tool.
> Remote controller registration is performed through "Immobilizer Key Registration", and this registers the immobilizer transponder code.
> It is possible to register up to 4 remote controllers in the keyless start control module.
> If the keyless start control module is replaced, you must reprogram all of the remote controllers. The TPMS sensors will also need to be registered again to the new controller.
> If all of the remote controllers are lost, the keyless start control module must be replaced before any remote controllers can be registered.
TOOLS REQUIRED
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.