Third Gear Band Apply Tube Removal

2009 Suzuki XL-7 2WD V6-3.6LSECTION Third Gear Band Apply Tube Removal
Third Gear Band Apply Tube Removal

Special Tool
J 28585 Snap Ring Remover





1. Remove the 2 third gear band apply retainer bolts/screws (50).
2. Remove the third gear band apply tube retainer (51).





NOTE:
^ Do not bend or damage the apply tube or the O-ring.
^ Do not damage the transmission case sealing surface.

3. Using J 28585, remove the third gear band apply tube (52) and O-ring (53).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.