SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP, RWDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSMISSION/TRANSAXLEDIAGNOSTIC INFORMATION AND PROCEDURESMAIN POWER SUPPLY AND GROUND CIRCUIT CHECK
2009 Suzuki Equator Sport, 4D Pickup, RWD

Main Power Supply and Ground Circuit Check

2009 Suzuki Equator Sport, 4D Pickup, RWDSECTION Main Power Supply and Ground Circuit Check
DIAGNOSTIC PROCEDURE

Step Action YES NO
1  CHECK TCM POWER SOURCE STEP 1 
  1. Turn ignition switch OFF.
  2. Disconnect A/T assembly harness connector.
  3. Check voltage between A/T assembly harness connector terminals and ground.
G06442821G06442822Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.