SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (VQ40DE) - (2 OF 5)DTC P0335: CKP SENSOR (POS)ON BOARD DIAGNOSIS LOGIC
2009 Suzuki Equator Sport, 4D Pickup, RWD

On Board Diagnosis Logic

2009 Suzuki Equator Sport, 4D Pickup, RWDSECTION On Board Diagnosis Logic
DTC DETECTING CONDITION AND POSSIBLE CAUSE

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0335
0335		 Crankshaft position sensor (POS) circuit
  • The crankshaft position sensor (POS) signal is not detected by the ECM during the first few seconds of engine cranking.
  • The proper pulse signal from the crankshaft position sensor (POS) is not sent to ECM while the engine is running.
  • The crankshaft position sensor (POS) signal is not in the normal pattern during engine running.
  • Harness or connectors (The sensor circuit is open or shorted)
  • Crankshaft position sensor (POS)
  • Signal plate
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.