Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (ENGINE COOLING SYSTEM (QR25DE))
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD
Section 7 (Engine Cooling System (Qr25DE))
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Section 7 (Engine Cooling System (Qr25DE))
WARNING: This page is about a different variant/trim than selected.
- Precautions
- Schematic and Routing Diagram
- Diagnostic Information and Procedures
- Repair Instructions
- Engine Coolant: System Inspection
- Changing Engine Coolant
- Radiator: Exploded View
- Radiator: Removal and Installation
- Checking Radiator
- Cooling Fan: Exploded View
- Cooling Fan: Removal and Installation (Crankshaft driven type)
- Water Pump: Exploded View
- Water Pump: Removal and Installation
- Thermostat and Thermostat Housing: Exploded View
- Thermostat Removal and Installation
- Water Pump and Thermostat Housing Removal and Installation
- Water Control Valve: Exploded View
- Water Control Valve: Removal and Installation
- Water Outlet and Water Piping: Exploded View
- Water Outlet and Water Piping: Removal and Installation
- Specifications
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.