Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 9 (CRUISE CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B0835CIRCUIT/SYSTEM TESTING
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD
Circuit/System Testing
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector C1 at the BCM.
- Ignition ON, verify that a test lamp does not illuminate between the steering wheel control supply voltage circuit terminal 17 and ground.
- If the test lamp illuminates, test the steering wheel control supply voltage circuit for a short to voltage.
- Ignition OFF, disconnect the harness connector C3 at the BCM.
- Ignition ON, verify that a test lamp does not illuminate between the cruise control indicator dimming signal circuit terminal 22 and ground.
- If the test lamp illuminates, test the cruise control indicator dimming signal circuit for a short to voltage. If the circuit tests normal, replace the steering wheel controls switch assembly - left.
- If all circuits test normal, replace the BCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.