Auxiliary Blower Control Module Replacement

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Auxiliary Blower Control Module Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Blower Control Module & Screws
G04844438Courtesy of SUZUKI OF AMERICA CORP.
CALLOUT COMPONENT NAME TABLE

Callout Component Name
Preliminary Procedure 
  1. Remove the left rear trim panel. Refer to REAR QUARTER LOWER TRIM PANEL REPLACEMENT .
  2. Remove the auxiliary HVAC module mounting bolts (Qty 3). Refer to AUX. HVAC MODULE REPLACEMENT
  3. Reposition auxiliary HVAC module inward to gain access to the blower control module.
  4. Disconnect electrical connection.

    Tip:  The blower control module is mounted on the outboard side of the module.

1 Blower control module screws (Qty 2).
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
1.5 N.m (13 lb in) 
2 Blower control module.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.