SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (AIR BAG SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT STEERING WHEEL MODULE COIL REPLACEMENT
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD

Inflatable Restraint Steering Wheel Module Coil Replacement

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Inflatable Restraint Steering Wheel Module Coil Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Inflatable Restraint Steering Wheel Module Coil & Bolts
G04844119Courtesy of SUZUKI OF AMERICA CORP.
COMPONENT REFERENCE TABLE

Callout Component Name
CAUTION: The new SIR coil assembly will be centered. Improper alignment of the SIR coil assembly may damage the unit, causing an inflatable restraint malfunction.
Preliminary Procedures 
  1. Remove the steering wheel. Refer to STEERING WHEEL REPLACEMENT .
  2. Remove the steering column trim covers. Refer to STEERING COLUMN TRIM COVERS REPLACEMENT .
1 Inflatable Restraint Steering Wheel Module Coil Bolts (Qty: 4)
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
1.5 N.m (13 lb in). 
2 Inflatable Restraint Steering Wheel Module Coil
Procedure 
  1. Disconnect any electrical connectors as needed.
  2. A new inflatable restraint steering wheel module coil will be equipped with a yellow tab that should be removed after the steering wheel is installed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.