SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (AIR BAG SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT FRONT END SENSOR REPLACEMENT
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD

Inflatable Restraint Front End Sensor Replacement

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Inflatable Restraint Front End Sensor Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Supplemental Inflatable Restraint Front End Discriminating Sensor Assembly & Bolts
G04844114Courtesy of SUZUKI OF AMERICA CORP.
COMPONENT REFERENCE TABLE

Callout Component Name
WARNING: Do not strike or jolt the inflatable restraint front end sensor. Before applying power to the front end sensor make sure that it is securely fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
Preliminary Procedure 
  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR DISABLING AND ENABLING .
  2. Left supplemental inflatable sensor requires to remove battery box. Refer to REMOVAL PROCEDURE
1 Supplemental Inflatable Restraint Front End Discriminating Sensor Bolt (Qty: 4)
CAUTION: Refer to FASTENER NOTICE .

Tip:  Loosen bolts in order to remove sensor.
Tightening torque 
8 N.m (71 lb in) 
2 Supplemental Inflatable Restraint Front End Discriminating Sensor Assembly (Qty: 2)
Procedure 
  1. Remove connector position assurance (CPA) retainer.
  2. Disconnect electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.