Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (CELLULAR/ENTERTAINMENT/NAVIGATION/AUDIO)DIAGNOSTIC INFORMATION AND PROCEDUREDTC B1529COMPONENT TESTING
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD
Component Testing
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Component Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refer to SIR CAUTION
.
- Ignition OFF, disconnect the harness connector at the suspect steering wheel control switch.
- Test for infinite resistance between the ignition terminal 3 and the signal terminal 4 with the switch in the open position.
- If less than specified value, replace the switch.
- Test for less than 5400 ohms of resistance between the signal terminal 4 and the ignition terminal 3 with the switch in the closed position.
- If greater than the specified value, replace the steering wheel control switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.