Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (WIRING SYSTEMS)REPAIR INSTRUCTIONDELPHI CONNECTORS (MICRO.64)REMOVAL PROCEDURE

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD

Removal Procedure

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to remove terminals from Micro .64 connectors.

Fig 1: Locating Lever Lock On Wire Dress Cover

Courtesy of SUZUKI OF AMERICA CORP.

Locate the lever lock on the wire dress cover. While depressing the lock, pull the lever over and past the lock. The lever lock may be located on the top or sides of the wire dress cover.

Fig 2: Identifying Typical Micro 64 Connector
Courtesy of SUZUKI OF AMERICA CORP.

View of a typical Micro 64 connector.

Fig 3: Depressing Lock
Courtesy of SUZUKI OF AMERICA CORP.

Depress the lock and pull the lever over and past the lock.

Fig 4: Identifying Connector
Courtesy of SUZUKI OF AMERICA CORP.

View of the connector when released from the component.

Fig 5: Identifying Micro 64 Connector
Courtesy of SUZUKI OF AMERICA CORP.

View of another type of Micro 64 connector.

Fig 6: Depressing Locks Of Wiredress Cover
Courtesy of SUZUKI OF AMERICA CORP.

Depress the locks that are located on both sides of the wiredress cover and pull the lever over and past the locks.

Fig 7: Identifying Connector
Courtesy of SUZUKI OF AMERICA CORP.

View of the connector when released from the component.
Disconnect the connector from the component.

Fig 8: Pushing Dress Cover Locking Tabs With Screw Driver
Courtesy of SUZUKI OF AMERICA CORP.
Locate the dress cover locking tabs at the front of the connector. Using a small flat-blade tool push down on one of the locking tabs and pull the cover up until the dress cover releases. Repeat this procedure for the other locking tab.
Once the front 2 locks are unlocked, lift the front of the dress cover and pull it forward.

Fig 9: Inserting Small Flat-Blade Tool Into Small Slot On TPA
Courtesy of SUZUKI OF AMERICA CORP.