Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 36 (TRANSFER)SCHEMATIC AND ROUTING DIAGRAMTRANSFER CASE CONTROL CONNECTOR END VIEWSREAR DIFFERENTIAL CLUTCH CONTROL MODULE C1
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD
Rear Differential Clutch Control Module C1
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Rear Differential Clutch Control Module C1
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Connector Part Information
OEM: 89047383
Service: -
Description: 10-Way F 0.64 Sealed (BK)
Terminal Part Information
Terminal/Tray: 7116-4618-02/14
Core/Insulation Crimp: P/P
Release Tool/Test Probe: J-38125-215/J-35616-64B (LBU)
REAR DIFFERENTIAL CLUTCH CONTROL MODULE C1 FUNCTION TABLE
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| 1-2 | - | - | Not Used |
| 3 | BK | 850 | Ground |
| 4 | - | - | Not Used |
| 5 | L-BU | 5986 | Serial Data Communication Enable |
| 6 | RD/WH | 1740 | Battery Positive Voltage |
| 7 | - | - | Not Used |
| 8 | TN | 2501 | High Speed GMLAN Serial Data Bus- |
| 9 | TN/BK | 2500 | High Speed GMLAN Serial Data Bus+ |
| 10 | - | - | Not Used |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.