Rear Side Door Window Switch Replacement

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Rear Side Door Window Switch Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rear Side Door Window Switch Assembly
G04845309Courtesy of SUZUKI OF AMERICA CORP.
REFERENCE TABLE

Callout Component Name
Fastener Tightening Specifications: Refer to  FASTENER TIGHTENING SPECIFICATIONS - FIXED AND MOVEABLE WINDOWS  . 
Preliminary Procedure 
  1. Remove rear door handle bezel. Refer to DOOR HANDLE BEZEL REPLACEMENT .
  2. Remove rear door trim panel. Refer to REAR SIDE DOOR TRIM PANEL REPLACEMENT .
1 Rear Side Door Window Switch Assembly
  1. Disconnect electrical connector.
  2. Use a flat-bladed tool to pry switch from door handle assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.