Power Mirror Switch Replacement

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Power Mirror Switch Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing Power Mirror Switch Assembly
G04845318Courtesy of SUZUKI OF AMERICA CORP.
REFERENCE TABLE

Callout Component Name
Preliminary ProcedureΒ 
Remove instrument panel left air outlet assembly. Refer to INSTRUMENT PANEL OUTER AIR OUTLET REPLACEMENT - LEFT SIDE .
1 Power Mirror Switch Assembly
Tip:Β  Reach through the outlet assembly hole, squeeze the tabs inward and push the power mirror switch out through the front of the trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.