Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 29 (ENGINE EXHAUST SYSTEM)REPAIR INSTRUCTIONSEXHAUST MANIFOLD HEAT SHIELD REPLACEMENT - RIGHT SIDEREMOVAL PROCEDURE
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD
Removal Procedure
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Refer to EXHAUST SERVICE CAUTION .
- Refer to PROTECTIVE GOGGLES AND GLOVE CAUTION .
- Remove the fuel injector sight shield, if necessary. Refer to REMOVAL PROCEDURE .
- Disconnect the engine wiring harness electrical connector (3) from the heated oxygen sensor (HO2S) electrical connector (2).
- Remove the HO2S electrical connector retainer from the camshaft cover.
- Remove the exhaust manifold heat shield bolts.
- Remove the exhaust manifold heat shield, sliding the shield up over the HO2S pigtail.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.