SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (WIPERS/WASHERS)REPAIR INSTRUCTIONSWIPER ARM REPLACEMENT
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD

Wiper Arm Replacement

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Wiper Arm Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Windshield Wiper Arm Assembly
G04845204Courtesy of SUZUKI OF AMERICA CORP.
WIPER ARM TABLE

Callout Component Name
Preliminary Procedure 
Open the hood in order to access the wiper arm assemblies.
1 Windshield Washer Wiper Arm Nut (Qty: 2)
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
28 N.m (21 lb ft) 
2 Windshield Washer Wiper Arm Assembly
  • Position wiper blade assembly at the dot in lower portion of windshield blackout strip on driver side of vehicle.
  • Position wiper blade assembly at the dot in windshield pillar portion of windshield blackout strip on passenger side of vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.