Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSFRONT SEAT LUMBAR SUPPORT REPLACEMENT

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD

Front Seat Lumbar Support Replacement

2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Front Seat Lumbar Support Replacement

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Seat Lumbar Support Components

Courtesy of SUZUKI OF AMERICA CORP.

FRONT SEAT LUMBAR SUPPORT COMPONENTS REFERENCE

Callout	Component Name
Preliminary Procedure Remove the front seat. Refer to FRONT SEAT REPLACEMENT - BUCKET .
1	Front Seat Head Restraint Refer to FRONT SEAT HEAD RESTRAINT REPLACEMENT .
2	Front Seat Head Restraint Guides Procedure Disconnect the lower J-hook retainer from the seat back trim cover. Carefully pull up the trim cover, disengaging the hook and loop retainers until the head restraint guides are exposed. Squeeze the locking tabs on the head restraint guide and pull the guides up and out of the seat back pad.
3	Seat Back Cushion Cover and Pad Refer to FRONT SEAT BACK CUSHION COVER AND CUSHION PAD REPLACEMENT (NON FOLD FLAT) and FRONT SEAT BACK CUSHION COVER AND CUSHION PAD REPLACEMENT (FOLD FLAT) .
4	Front Seat Back Lumbar Adjust the lumbar knob until the lumbar is at the position of the least support. Remove the lumbar cable end from the lumbar unit by compressing the unit while lifting out the barrel end of the cable assembly at the actuator. Using a flat-bladed tool, twist out the upper portion of the lumbar unit from the seat frame cross wire. Using a flat-bladed tool, twist out the lower portion of the lumbar unit from the seat frame cross wire.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.