Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2009EQUATOR SPORT, 4D PICKUP EXTRA CAB, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (DATA COMMUNICATION SYSTEM)DIAGNOSTIC INFORMATION & PROCEDURESPOWER MODE MISMATCHCOMPONENT TESTING
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WD
Component Testing
2009 Suzuki Equator Sport, 4D Pickup Extra Cab, 4WDSECTION Component Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Ignition Switch
Using the Resistance Test below, check the resistance between the pins of the ignition switch listed in each switch position listed.
- If any reading is other than specified, replace the ignition switch.
RESISTANCE TEST REFERENCE
| Ignition Switch Position | Pins 3 and 1 | Pins 3 and 2 | Pins 3 and 5 | Pins 3 and 4 | Pins 5 and 4 |
|---|---|---|---|---|---|
| Off Key Out | Infinite | Infinite | Infinite | Infinite | Infinite |
| Off Key IN | Infinite | Infinite | < 5.0 Ω | Infinite | Infinite |
| Accessory | Infinite | < 5.0 Ω | Infinite | Infinite | Infinite |
| Run | < 5.0 Ω | < 5.0 Ω | Infinite | Infinite | < 5.0 Ω |
| Start | < 5.0 Ω | Infinite | Infinite | Infinite | 1275-1325 Ω |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.