Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Suzuki Swift +SECTION Installation Procedure
- Clip the contact ring on the steering wheel, if necessary.
- Align the match marks on the steering wheel and the steering column shaft. Turn the signal-canceling cam on the wheel to the left.
- Install the retaining clip and the steering wheel nut.
Tighten: Tighten the steering wheel nut to 38 N.m (28 lb ft).
- Bend the tabs to secure the retaining clip.
- Install the SIR module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.