Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditions for Running the DTC (w/TAC)
2008 Suzuki Swift +SECTION Conditions for Running the DTC (w/TAC)
- The engine is idling.
- The engine run time is greater than 2 seconds.
- The evaporative emission (EVAP) purge flow is less than 100 percent.
- The barometric pressure (BARO) is greater than 72 kPa.
- The intake air temperature (IAT) is greater than -20°C (-4°F).
- The engine coolant temperature (ECT) is greater than -10°C (+14°F).
- The ignition voltage is between 11-16 volts.
- The DTCs run when the above conditions are met for 3 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.