Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2005 Suzuki Swift +SECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Install the control module/receiver on its mounting bracket.
- Connect the control module/receiver electrical connector.
- Install the knee bolster with bolts.
Tighten: Tighten the driver's side knee bolster mounting bolts to 10 N m (89 lb in).
- Install the instrument panel under cover.
- Connect the hood release cable to the hood latch release handle.
- Install the screws.
- Connect the negative battery cable.
- Complete remote keyless transmitter programmming. Refer to Transmitter Programming
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.