Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2005 Suzuki Swift +SECTION Installation Procedure
- Install a new brake pedal cover, if needed.
- Coat the pedal shaft with grease.
- Position the brake pedal on the pedal-to-dash panel bracket and the pedal shaft.
- Place the nut on the pedal mounting shaft.
Tighten: Tighten the brake pedal-to-pedal bracket nut to 22 N.m (16 lb ft).
- Install the pushrod to the pedal with the pin and the retaining ring.
- Install the spring on the shaft in its original position.
- Connect the stop lamp switch and the connector assembly by twisting it into the pedal bracket.
- Install the trim panel with the screws.
Tighten: Tighten the trim panel screws to 7 N.m (62 lb in).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.