Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditions for Setting the DTC
2005 Suzuki Reno EXSECTION Conditions for Setting the DTC
- Transmission oil temperature is greater than -10°C (14°F).
- Selector lever is not N (Neutral), P (Park) position.
- System voltage is greater than 9 volts.
- No input speed error DTCs P0715, P0716, and P0717.
- Output speed is greater than 256 RPM.
- Input speed is greater than 400 RPM.
- 1-2 gear shift is active.
- Immediately after the above condition occurs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.