Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2005RENO EXREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGPOWER ASSISTED STEERING SYSTEMREPAIR INSTRUCTIONSINTERMEDIATE SHAFT AND DASH SEAL REMOVAL AND INSTALLATIONINSTALLATION

2005 Suzuki Reno EX

Intermediate Shaft and Dash Seal Removal and Installation: Installation

2005 Suzuki Reno EXSECTION Installation

Install the intermediate shaft into the vehicle.

Fig 1: Identifying Intermediate Shaft
Courtesy of SUZUKI OF AMERICA CORP.
Install the dash seal retaining ring with the nuts.
Tighten

Tighten the dash seal retaining ring nuts to 7 N.m (62 lb-in).

Fig 2: Identifying Dash Seal Retaining Ring Nuts
Courtesy of SUZUKI OF AMERICA CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.